Measuring Insulation Resistance - Ideal 61-797 Manual De Instrucciones

All manuals and user guides at all-guides.com

Measuring Insulation Resistance

V
DC
Press
TEST
&
Hold
TEST
V
DC
=
TEST
~
+
1. Before starting the test:
The circuit under test must be completely de-energized. If the
voltage detected is above 30V, ">30V" will appear on the display.
In this condition, the test is inhibited.
2. Press the blue button to display insulation resistance or Leakage
current during the test or when the test stops.
3. Lock mode: Press the Lock button to enter the Lock Mode. Then
press TEST button to start the test. The test voltage will continue to
be applied until the TEST/LOCK button is pressed again.
4. Release the TEST button before removing the test leads (to enable
the tester to discharge capacitive circuits). If the screen displays
volts, wait until it reaches zero.
5. The meter displays the ">" symbol and the maximum resistance
for the range when measured resistance is higher than the maximum
display range.
MΩ
MEM AUTO SENSE
MΩ
COMP
TEST
0
50V
Ω
LP
V
OFF
Ω
COM
–
FUSED
7
61-797
TEST LOCK APO LPF
V
AC
DC
KMΩ
GΩ
0
µmA
V COMPARE
AC 100200
PI DAR 500KMΩ
DC
RECALL PI/DAR
STORE LOCK
PASS
100V
250V
500V
1000V
V
>600V
INSULATION
CAT. IV
600V
500V