Optional Accessories; Replacing Carbon Brushes - Makita DSS500 Manual De Instrucciones

Ocultar thumbs Ver también para DSS500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the like.
Discoloration, deformation or cracks may result.
Adjusting for accuracy of 90° cut
(vertical cut)
This adjustment has been made at the factory. But if it is
off, adjust the adjusting screws with a hex wrench while
inspecting 90°
the blade with the base using a
triangular rule or square rule, etc.
1
007981
1
007982

Replacing carbon brushes

1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
All manuals and user guides at all-guides.com
007983
After replacing brushes, insert the battery cartridge into
the tool and break in brushes by running tool with no
load for about 1 minute. Then check the tool while
running and electric brake operation when releasing the
switch trigger. If electric brake is not working well, ask
your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
1. Adjusting screw
any other maintenance or adjustment should be
for 90 ゚
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

1. Triangular rule
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
006540
1. Limit mark
NOTE:
11
1
2
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
Carbide-tipped saw blades
General purpose blade for fast and smooth rip,
Combination
crosscuts and miters.
Rip fence (Guide rule)
Hex wrench 5
Dust nozzle
Makita genuine battery and charger
Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
1. Brush holder
cap
2. Screwdriver
or
attachments
are
Only use
accessory or

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dss501

Tabla de contenido