46
3.3.1a - MODELS
25GL VAP / 45GL VAP / 46PL VAP / 61GL VAP / 64PL VAP / 101GL VAP / 104PL VAP
SWITCHING ON/OFF
When power is connected, the panel shows the software version
message for a few seconds. Then the oven switches itself OFF,
the LED on the time display lights up and the oven remains in
standby.
Pressing ON/OFF:
turns on the panel:
all the displays come on while waiting for the set point to be
entered:
default temperature 100 °C,
default timer 000,
default humidity 0.
Once the temperature has been set by turning the corresponding
knob, the display continues to flash for 15 seconds and then
accepts the data entered, unless another knob is turned, in which
case the data is accepted immediately and the display on the
second knob flashing while waiting for the set point.
Once the time has been set by turning the corresponding knob,
the display continues to flash for 15 seconds and then accepts
the data entered, unless another knob is turned, in which case
the data is accepted immediately and the humidity display
flashes automatically.
Once the humidity data has been set by turning the
corresponding knob, the display continues to flash for 15
seconds and then accepts the data entered.
During the cooking cycle, it is possible, while altering the set
parameters, turning the corresponding knob (temperature, time,
humidity), to change the parameters, waiting for 15 seconds or
turning a knob.
If the oven is in stop mode and no operation is performed for
more than 15 minutes, the oven automatically switches off as if
the OFF button had been pressed.
The ON/OFF button is disabled during a cooking cycle. To make
it active, you must first press the START/STOP button.
When the oven goes off, either because the ON/OFF button
has been pressed or at the end of a cooking cycle, the last set
parameters are stored for 5 minutes. 5 minutes after switch-off,
the panel returns to the initial data entry mode when switched
back on.
pict. 23
GB
ELECTRIC VENTILATED OVENS