Configuration - urmet domus 1092/601 Manual De Instrucciones

CONNECTIONS

Connect the wire (included) to the dome using the terminal boards.

Connect the second end of the wire to the video device by means of the male BNC connector.

Connect the two wires of the RS485 by means of the terminal board or by welding to the control panel
socket (Ref. 1092/620) respecting the following polarities: ORANGE + (positive) - YELLOW –
(negative).

Connect the two power wires by means of the terminal board or by welding the two wires of the power
supply unit (included). Polarity does not need to be respected.

If the dome is the last device on the RS485 line (see LOGICAL CONNECTION OF THE RS485
LINE), connect a 120 Ohm ¼ w resistor (not included) to the RS485 line.

Connect as shown in "CONNECTION DETAILS".

Plug the power unit into the mains.

CONFIGURATION

INSERT THE 120 OHM ¼ W RESISTOR IF
THE DEVICE IS THE LAST ONE OF THE
LINE
LOGICAL CONFIGURATION OF THE RS485 LINE
KEYPAD
Important note:
The sum of each segment of the RS485 line must never exceed 1200 m.
DS1092-041C
All manuals and user guides at all-guides.com
JACK
Figure 2: MINIMUM CONFIGURATION
Connection wire
Dome power supply unit
COAX
RS485
Insert resistor
35