urmet domus 1092/601 Manual De Instrucciones página 51

Proceed by storing preset positions to be included in the tour, up to 16, following the previously described
steps.
After entering all the required presettings and parameters, press "ON" to end the operation.
In brief:
1. Tour n. (from 1 to 6) + "TOUR" + "ON"
2. DOWN
3. Preset n. (previously stored from 1 to 32)
4. DOWN
5. Panning speed (from 0 to 9)
6. DOWN
7. Pause time on each presetting (from 0 to 9)
8. DOWN
Repeat from step 3 to step 8 to enter the other presettings (maximum 16).
End the setting as follows:
9. ON
In standby mode, press "TOUR". Then use the number buttons to indicate the tour to be displayed (from 1
to 6). Then press "ON" to start the tour or press "CLEAR" to go back directly to standby mode. Press any
button "UP", "DOWN", "LEFT" or "RIGHT" to stop the track tour in progress.
Important note: The track tour in progress is interrupted when new commands are imparted using the
control panel (e.g. by pressing "UP", "DOWN", "LEFT" or "RIGHT").
In standby mode, select the tour to be deleted using the number keys (from 1 to 6). Press "TOUR" and then
"OFF" to enter tour deletion mode. Enter the number of the tour to be deleted using the number keys. Then
press "OFF" to delete the tour or "CLEAR" to cancel the operation and go back to standby mode.
In standby mode, press "PRESET + 51 + ON". Press any button "UP", "DOWN", "LEFT" or "RIGHT" to stop
the function in progress.
This function consists is returning the dome automatically to preset position 1 in the previously set time
without imparting any control.
The waiting time before returning to preset position 1 may be chosen between 1 minute, 2 minutes, 4
minutes, 8 minutes and 10 minutes.
Press "CAL+100+ON" to activate the function from the panel.
To set 1 minute, press "CALL+95+ON".
To set 2 minute, press "CALL+96+ON".
To set 4 minute, press "CALL+97+ON".
To set 8 minute, press "CALL+98+ON".
To set 10 minute, press "CALL+99+ON".
Press "PRESET+100+ON" to deactivate the function.
DS1092-041C
All manuals and user guides at all-guides.com
Recalling a stored track tour
Deleting a stored track tour
Activating the default tour
Setting home position
51