urmet domus 1092/601 Manual De Instrucciones página 49

DESCRIPTION OF FUNCTIONS AVAILABLE IN COMBINATION WITH CONTROL
PANEL REF. 1092/620

64 preset positions: This function is used to store up to 50 presetting fixed positions for use with the
functions described below. The remaining 14 preset positions are used by the dome for special
functions and cannot be changed. The preset position settings will be stored in event of a blackout.

Panning between two preset positions: This function is used to pan between two previously stored
preset positions. The most suitable speed (from 0 to 80 degrees per second) may be selected.

Six programmable track tour groups: This function is used to set a sequence of frames which will
be displayed in the programmed order (tour). Each tour may comprise 16 preset positions. The
current speed and the pause time can be programmed by the user. The data will be stored following a
blackout.

Default tour: This consists of the first 16 preset positions. If one or more preset positions are not
stored, they cannot be taken into consideration and the tour will only include the preset positions
which are present. The pause time between preset positions is fixed to 4 seconds and cannot be
changed.

Home position: This function is used to automatically position the dome in preset position 1 (home
position) if no controls are imparted from the control panel after a certain time.

Continuous 360° scan: This function is used to turn the dome by 360° about its axis at the
previously programmed pan position and speed.

Repeat last function: This function is used to resume the last action that the domes was performing
before being interrupted by a user's operation.
Important note: The user's settings will be stored in event of a blackout. If a function is interrupted in
progress, the dome will automatically resume the position which was being performed as soon as the
electrical power supply will be re-established.
DS1092-041C
All manuals and user guides at all-guides.com
49