Rearpanel; Installation - Omnitronic DJS-1200 Manual Del Usuario

All manuals and user guides at all-guides.com

4.3 Rearpanel

38. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
39. FADERSTART-SOCKET
Via the Faderstart-socket, the CD-player can be remotely controlled. If you are using a mixer with Faderstart-
function connect the player with the Control Out-socket. Please note that these sockets must never be
connected with any voltage. Please refer to the explanations 6.13 Faderstart.
40. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
41. HEADPHONES SOCKET
With this socket, you can connect headphones with an impedance between 8 Ohms and 600 Ohms.
42. VOLUME-CONTROL
With the Volume-control, you can adjust the headphones volume.
43. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
44. AC CONNECTION
Plug the power supply cable in here.
45. POWER SWITCH
Press this button to start operation.

5. INSTALLATION

Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
29/69 10602296X10NXS_V_1_0.DOC