Symbols; Safety Warnings - Festool MFK 700 EQ Manual De Instrucciones Original

Contents
1 Symbols..................................................... 15
2 Safety warnings.........................................15
3 Intended use..............................................16
4 Technical data........................................... 16
5 Parts of the device.....................................16
6 Commissioning..........................................17
7 Settings......................................................17
8 Working with the electric power tool........18
9 Service and maintenance..........................19
10 Accessories............................................... 19
11 Environment.............................................. 19
12 General information.................................. 20
1

Symbols

Warning of general danger
Warning of electric shock
Read the operating instructions and
safety instructions.
Wear ear protection.
Wear a dust mask.
Wear protective gloves when changing
tools and working with raw materials.
Wear protective goggles.
Disconnecting the mains power cable
Connecting the mains power cable
Safety class II
Do not dispose of it with domestic
waste.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tip or advice
Handling instruction
UKCA marking: The United Kingdom
Conformity Assessed symbol is a
marking for products being placed on
the market in the United Kingdom. It is
a manufacturers indication that the
product is in conformance with the rel­
evant regulations in the UK.
2

Safety warnings

2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
2.2 Machine-specific safety notices
Hold the power tool by insulated gripping
-
surfaces only, because the cutter may
contact its own cord. Cutting a "live" wire
may make exposed metal parts of the pow­
er tool "live" and could give the operator an
electric shock.
Use clamps or another practical way to se­
-
cure and support the workpiece to a stable
platform. Holding the work by your hand or
against the body leaves it unstable and may
lead to loss of control.
- Do not clamp tools with an unsuitable
shank diameter in the clamping collet.
- Operate power tool only with properly in­
stalled guide table and extraction hood
- Only cutters provided by Festool for this
purpose may be mounted on the power
tool. The use of other cutters is prohibited
due to the increased risk of injury.
- Only use tools that meet standard
EN 847-1. All Festool routing tools fulfi l
these requirements.
- The clamping collet and locking nut must
not show any signs of damage
- Do not use cracked or deformed router
bits.
- Ensure that the router bit is seated firmly
and that it runs perfectly.
The maximum rotational speed specified
-
on the tool must not be exceeded or the
rotational speed range must be observed.
English
15