Publicidad
Idiomas disponibles
Idiomas disponibles
Product use
Installation concerns
This infant carrier module is suitable for vehicle seats with
i-Size ISOFIX anchor points with the Base. (1)
DO NOT use the rearward facing enhanced child restraint
systems in seating positions where there is an active
frontal airbag installed. Death or serious injury may occur.
(2) Please reference vehicle owner's manual for more
information.
DO NOT install this enhanced child restraint on vehicle
seats that face sideways or rearward with respect to the
moving direction of the vehicle. (3)
It is recommended to install this enhanced child restraint on
the rear vehicle seat. (4)
DO NOT install this enhanced child restraint on vehicle
seats movable during installation.
Handle adjustment
1
The handle of the infant carrier module can be adjusted
to 3 positions. (5)
Baby chair position. (5)-1
Position for placing the baby in the seat. (5)-2
Position for car, hand or stroller transportation. (5)-3
2
To adjust the handle, squeeze handle buttons on both
sides to release it. (6)-1
3
Rotate handle until it clicks into any of the 3 positions.
(6)-2
14
BGB Nuna Turtle 2 UG_rv001 Part1 120x170.indb 14-15
BGB Nuna Turtle 2 UG_rv001 Part1 120x170.indb 14-15
All manuals and user guides at all-guides.com
Installation with base
1
2
3
4
5
Unfold the load leg from storage compartment. (7)
Fit the ISOFIX guides with the ISOFIX anchor points.
(8) The ISOFIX guides can protect the surface of the
vehicle seat from being torn. They can also guide the
ISOFIX connectors.
Press the ISOFIX Adjust Button to adjust the ISOFIX
connectors. (9)
Line up the ISOFIX connectors with the ISOFIX guides,
and then click both ISOFIX connectors into the ISOFIX
anchor points. (10)
Make sure that both ISOFIX connectors are securely
attached to their ISOFIX anchor points. There should
be two audible clicks and the colors of the indicators
on the both ISOFIX connectors should be completely
green. (10)-1
Check to make sure the base is securely installed by
pulling on the both ISOFIX connectors.
After placing the base on the vehicle seat, extend the
load leg to floor (11). When the load leg indicator shows
green means it is installed correctly, red means it is
installed incorrectly. (11)-2
The load leg has 19 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is in full contact with the vehicle
floor pan.
To shorten the load leg, squeeze the load leg release
button and pull the load leg upwards. (11)-1
The completely assembled base is shown as (12).
The ISOFIX connectors must be attached and locked
onto the ISOFIX anchor points. (12)-1
15
22-02-2020 18:33
22-02-2020 18:33
Publicidad
Capítulos
