Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL FLUE MOUNTING
BRACKET
DUCTED AND NON-DUCTED
1. Assemble the fl ue mounting bracket, adju-
sting outside width as shown. (Fig.10)
2. Carefully center the mounting bracket
directly over the range hood location.
3. Secure the bracket assembly to the cei-
ling
using (2) 4.8 x 38mm mounting
screws and drywall anchors (Fig.11).
Make sure the bracket is pushed into the
corner, tight against the wall if necessary,
and centered over the hood. Complete the
installation.
INSTALL THE HOOD
DUCTED AND NON-DUCTED INSTALLA-
TION
1. Remove the electrical system box from
chimney frame by removing (2) 3.9 x 9.5
mm screws. Fig. 12.
2. Attach electrical system box to frame using
(2) 3.9 x 9.5 mm screws removed in Step 1
and (2) 3.9 x 9.5 mm screws and (2) lock
washers from hardware bag.
3. Install hood onto the wall mounting
brackets. Fig. 13. Adjust leveling screws on
mounting brackets to level hood with fl oor.
4. Mark and install (2) additional screws
as shown. Use drywall anchors only if
necessary.
ELECTRICAL
SYSTEM BOX
REMOVE (2)
3.9 x 9.5 mm
SCREWS
FIG. 12
MOUNTING SCREWS
- 13 -
MOUNTING SCREWS
(3.9 x 6 mm Flat Head)
DRYWALL
ANCHORS
(4.8 x 38mm)
3.9 x 9.5 mm
LOCK WASHERS
ON (2) SCREWS
MOUNTING SCREWS
4.8 x 38 mm
FIG. 10
FIG. 11
INSTALL (4)
SCREWS &
FIG. 13
Publicidad
