Changing The Thrust Direction - Vetus ELINE050 Instrucciones De Instalación Y Manual De Manejo

Always perform the following 2 configurations
first: - whether the panel is to operate a port or
n
ote
starboard motor (see 8 .6) and
8 .8

Changing the thrust direction

If, during the test run, it appears that the movement of the boat is
opposite to the direction in which the lever is moved, this can be ad-
justed as follows.
Carry out the following actions on EACH panel in the order
indicated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "ON/OFF" button to turn the panel
to the OFF position.
1
10 seconds
1. Place the panel in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
2
2 x
2. Press the "ON / OFF" button twice. Now the panel is in configura-
tion mode.
4. If the LED edge of the 'ON/OFF'
button is red: move the lever
once to the left. The LED edge
now turns blue and the thrust
direction has been changed.
OR
5. When the LED edge of the
'ON/OFF' button is blue: move
the lever once to the left. The
LED edge now turns red and
the thrust direction has been
changed.
34
370301.01
dididididididid ( . . . . . . )
6 seconds
didahdi ( . − . )
4
RED
5
BLUE
- at which helm position the panel is placed (see 8 .7) .
Then change the thrust direction if necessary .
Settings are retained when the power supply is switched off!
dididididah ( . . . . − )
Con guration mode
4 seconds
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -).
3
3. The LED at the "ON/OFF" button will now simultaneously flash
blue and red and a continuous audible signal will be heard.
1 x
BLUE
1 x
RED
vetus® Installation instructions and operation manual E-Line electric propulsion
n
ote
BLUE and RED,
simultaneously
ashing
6
1 x
6. Press the 'ON/OFF' but-
ton once to confirm
the setting.