Installation Of The Indoor Unit - Kentatsu KSGRE26HZAN1 Manual De Instalación Y Funcionamiento

Tabla de contenido

Idiomas disponibles

 First make changes to wall and make sure that is hard and secure. Using four»+» type screws to fasten the

instalIatior board onto the wall. Keep it water lever horizontal direction and perpendicular in vertical direction.

Otherwise it might cause water drops when air-conditioner is running cooling operation.

 Drilling 70mm diameter pipe hole at the left down or

right down side of the installation board. The hole shall

slant outward slightly.

 Pull out the indoor unit pipes after detached the ﬁ xed parts on them. Connect the interconnected pipes to the indoor unit; point to the

center of pipe and fasten the connection screw at ﬁ rst by hand and then by wrench until you hear the «Click» sound. Fastening direction is

shown in the right picture. Using torque is shown in the following table.

 Before installation, conﬁ rm connection pipes' direction. Remove the board 1 and

board 2 on the correct connecting side. Press connection pipes to the board gap,

then install board 2 to the original location. If connection pipes are on the other

side, install them as above.

Dural drainage feature AC can be installed as below chart shows:

 Drainage pipe can be connected to the connector 1 and connector 2. If it's necessary

to adjust drainage pipe to the other connector, remove rubber stopper from this side

and ﬁ x drainage pipe to it, then ﬁ x the rubber stopper to the other connector to make

it blocked up.

ATTENTION!

Please use tools like screwdriver to Insert into the back hole of the rubber stopper and

plug it to the connector when you want to make the connector blocked up.

Wall

Air-conditioner

Cable

Connection pipe

Out ow tube

Installation

Cable

board