Care And Maintenance - Kentatsu KSGRE26HZAN1 Manual De Instalación Y Funcionamiento

CLEANING
Cleaning the indoor unit
1. Turn off the air-conditioner and remove the electrical plug from the outlet.
2. Wipe the indoor unit with dry cloth or wet cloth which is dipped by cold water.
NOTE:
 Don't use water above 45°C to wash the panel, or it
could cause deformation or depigment.
 Don't use thinner, polishing powder, benzene and
other volatile chemicals.
 Don't use liquid or corrosive detergent clean the
appliance and don t splash water or other liquid
onto it, otherwise, it may damage the plastic com-
ponents, even cause electric shock.
Cleaning air lter
Front panel
Air lter
1. Raise up the front panel of indoor unit until it suddenly stop, then raise up the protruded part of air fi lter, and then take it out.
2. Use a vacuum cleaner or wash them with water, then dry it in the shade.
3. Reinsert the air fi lter into the indoor unit until being entirely fi xed, then close the front panel.
Select «FAN» operation mode,
make the air conditioner run a
long time to dry.
Check the following before requesting on service centre if the malfunction occurs.
Phenomenon Trouble shooting
 Has the power been shut down?
 Is the wiring loose?
Air conditioner dose not
 Is the voltage higher than 1.1 times of max rated voltage or lower than 0.9 times of min rated voltage?
operate at all
 Is the fuse burnt?
 Does it reach the set time for start up?
 Is the remote controller out of eff ective distance to the indoor unit?
Remote controller is not
 Is the battery exhausted?
available
 Are there any obstructions between the controller and the signal receptor?

CARE AND MAINTENANCE

Maintenance
Turn off the air conditioner and
cut off the power supply.
TROUBLESHOOTING
7
Front panel
Air lter
Take out the batteries from the
remote controller.
Clean air fi lters and other parts.