Publicidad
Idiomas disponibles
Idiomas disponibles
JOG WHEELFOR EFFECT PARAMETERS SETTING
TIME PARAMETER (X)
Press X (Time) button lights up and use Jog Wheel to set Time Parameter.
1) If HOLD button is not lit (dissabled) any parameter variation will be momentary.
2) If HOLD button is lit (active) any parameter variation will remain
NOTE: When HOLD button is active (lit), FX BEAT SYNC is deactivated.
RATIO PARAMETER (Y) "Balance Dry/Wet"
Press Y (Ratio) button lights up and use Jog Wheel to set Ratio Parameter.
1) If HOLD button is not lit (dissabled) any parameter variation will be momentary.
2) If HOLD button is lit (active) any parameter variation will remain
NOTE: When HOLD button is active (lit), FX BEAT SYNC is deactivated.
EFFECTAUTOMATIC BEAT SYNCRONY
Echo and Flange effecs are "space effects" and its behaviour is set by the Time parameter.
Filter effect is not s "space" effect but is can be set also by the Time parameter.
To activate FX BEAT SYNC mode press button FX SYNC (31), a Green LED lights up.
Use the buttons (</>) placed at the sides of the LEDs row to select the Beat Syncrony of
your choice between values entre ¼, ½, ¾, 1, 2, 4 Beat. The appropriate LED will light.
Use the buttons </>to select the Beat Syncrony. You can modify the Beat Syncrony in real
time while the effect is active pressing the buttons </>.
7- LINK K2 UNITS
With this function a USB device can be loaded into one K2, and played by a connected Host
USB Player. Follow the directions below to setup the link function. This function cannot be
used with the CD Player.
MAIN PLAYER:
1. Press the ENTER (SETUP MODE) button to enter the internal menu.
29
All manuals and user guides at all-guides.com
D - STEP BY STEP FOR IMPORTANT OPERATION
LED: Green
2. Once you are in the internal menu, turn the FOLDER knob until MIDI SETUP is
displayed.
3. Press the SHIFT button and turn TRACK knob until the USB = LINK is displayed, and
press the ENTER (SETUP MODE) button to save the setting and exit.
4. Now load your USB1 device into the MAIN PLAYER.
5. Connect the MAIN PLAYER using the rear USB MIDI port to the second player top USB
port.
6. You should now be able to access the main player loaded USB device using the second
player controls.
(The USB1 device must be read first on the main player top USB1 whenever loaded the
device.)
MAIN UNIT "MASTER"
USB CABLE: max. Length 1 meter. Min. Diameter 28
LINKED UNIT "HOST"
USB CABLE
mm
Publicidad
