Electrical Installation - SICK GSE2 Flat Side Serie Instrucciones De Uso

4
OPERATING AND STATUS INDICATORS
5 Mounting
en
6

Electrical installation

6 O P E R A T I N G I N S T R U C T I O N | GSE2 Flat Side
1 2
LED indicator green: supply voltage active
1
Receiver: LED indicator yellow: status of received light beam
2
Mount sensors (sender and receiver) using suitable mounting brackets (see the SICK
range of accessories). Align the sender and receiver with each other.
The minimum distance between sender and receiver is:
•
GSE2F(S)-xxx1xx: 24 mm
• GSE2F(S)-xxx2xx: 72 mm
• GSE2F(S)-xxx5xx: 238 mm
NOTE
Swap the sender and receiver arrangement at every second through-beam photoelec‐
tric sensor and ensure that there is sufficient distance between the through-beam
photoelectric sensors.
Sender (GS)
Receiver (GE)
Sender (GS)
Figure 1: Arrangement of several through-beam photoelectric sensors
Note the sensor's maximum permissible tightening torque of 0.1 Nm.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
1 2
Receiver (GE)
Sender (GS)
Receiver (GE)
= 0 V). The following informa‐
V
8023329.1C14/28.06.2021 | SICK
Subject to change without notice