Configuration - OHAUS i-DT33P Manual De Instrucciones

CONFIGURATION

The Ethernet option board is connected to the i-DT33P and i-DT33XW indicator
through the RS232 interface. The baud rate is 19200.
If the option board is not connected, the submenu will not display.
Reset
IP Address
Version
Ethernet
Alt Print CMD
Alt Tare CMD
Alt Zero CMD
End
For printing template setup, please refer to the following table
Reset
Assignment
Print
Setup
Checksum [MT-Continuous]
Template
End
Note: \ refers to not applicable in the table above.
no, yes
169.254.1.1-9761
1.03
A~Z, P
A~Z, T
A~Z, Z
\
Stable Weight Only
[Demand]
Mode [Auto On Stable]
Time [Interval(seconds)]
Link to [OH-Continuous]
no, yes
Demand, Auto On Stable, Auto On
Accept, Interval (seconds), MT-
Continuous, OH-Continuous, SICS
Off, On (LFT is forced to be On)
Load, Load and Zero
1~5000
Off, Custom 1, Custom2
On, Off
Custom 1, Custom 2
\
EN-11