Analog Configuration - OHAUS i-DT61XWE Manual De Instrucciones

EN-4

ANALOG CONFIGURATION

Upon installation, the indicator will recognize the Analog Kit and add
relevant items to the menu.
Reset
Source
Output Type
Zero Value
Analog Full Scale
Value
Cal Output
Zero
Cal Output
Full
End
SPECIFICATION
The analog output provides an isolated 4-20 mA or 0-10 VDC analog
signal. The analog output uses a 16-bit D/A converter for a very precise
output.
Maximum Cable
Length
Recommended Wire
Size
Min/Max Load
Resistance
Nonlinearity
Outputs
Resolution
Note: If the load resistance ratings exceeds, the analog output will not
operate properly.
no, yes
Displayed Weight, ABS-Displayed Weight,
Gross Weight
4-20mA, 0-10V
0 (any valid value below the high limit)
Desired source value, scale capacity
\
\
\
0-10 VDC
50 ft (15.2 m)
2
0.5mm
100k ohms
minimum
<0.3 %F.S
1 channel capable of supplying 4-20 mA or 0-
10 VDC
16 bit resolution, 65536 levels across entire
range
4-20mA
1000 ft (300 m)
500 ohms maximum