Using The Parking Aid - Waeco MagicWatch MWE910 Instrucciones De Montaje Y De Uso

All manuals and user guides at all-guides.com

Using the parking aid

10 Using the parking aid
Supplementary to fig. k
The rear sensors are activated automatically by engaging the reverse gear
with the ignition on or the engine running.
The front sensors are activated automatically once the speed of the vehicle
is between 0 and 10 km/h and the ignition is switched on.
If the speedometer signal cannot be detected, the front sensors are activated
when the ignition is switched on. After the adjustable switch-off time has
elapsed they are deactivated automatically. A MWS-910 switch (accessory)
can also be installed for activating the front sensors.
As soon as there is an obstacle within the detection range, a repeated signal
tone is emitted.
As you approach, the tone sequence changes, depending on the zone in
which the obstacle is, thus indicating the distance (fig. g applies to the front
sensors).
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps.
Caution
a
Stop the vehicle immediately and investigate the situation (getting
out if necessary), if the following happens while you are manoeu-
vring:
when manoeuvring, the device first indicates an obstacle and the
tone sequence speeds up normally (e.g. from slow to medium).
Suddenly the signal tone slows down, or no obstacle is indicated at
all.
This means that the original obstacle is in the blind spot of the sen-
sors (construction-related characteristic), and it is possible to hit it.
22
MagicWatch MWE910