GETTING STARTED
INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 3x AA (LR6)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3. Reattach the battery door.
NOTE: Replace batteries when [
when the display is dim.
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 1 Sensor is included with delivery.
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3.Select a channel, then press TX.
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
8
TO SEARCH FOR A SENSOR:
The main unit will automatically search for a new
sensor after the batteries are installed. To manually
initiate a outdoor sensor search, press and hold
[SENSOR].
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
] displays, or
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC
reception is initiated. To manually start RCC
reception press the [ – /
2. The receiving process duration is 7 minutes.
3. During receiving process, the RCC signal symbol
shows:
4. If the RCC receiving process is successful, a
completed RCC symbol [
the display and the date and time will be set
automatically. If it fails within 7 minutes, RCC
setting will quit automatically. If that happens, press
.
[
]
] button.
] will be shown in