Delta 20-330 Manual De Instrucciones página 14

ADJUSTING BLADE GUIDE BRACKETS
Disconnect machine from power source.
The left and right blade guide brackets (A) and (B) Fig.
22, are adjustable by loosening the two lock knobs (C)
and sliding the brackets to accommodate the width of
the work piece. The guide brackets (A) and (B) should
be set as close as possible to the workpiece, without
interfering or touching the workpiece, or contacting the
table. Once the adjustment is made, tighten the lock
knobs (C).
ADJUSTING FEED RATE
Disconnect machine from power source.
The feed rate of the saw arm can be adjusted by turning
the control arm (A) Fig. 23, counterclockwise to increase
or clockwise to decrease the feed rate. Do not turn the
control arm more than one turn at a time. Excessive
feed pressure can break or stall the blade. Insufficient
feed pressure dulls the blade rapidly.
OPERATING AND
ADJUSTING THE VISE
Disconnect machine from power source.
The workpiece (A) is placed between the vise jaws with
the required amount to be cut-off extending out past
the blade, as shown in Fig. 24. To tighten the workpiece
in the vise, turn handwheel (B).
The vise can be adjusted to cut any angle from 0
degrees to 45 degrees by loosening the two screws
(C) Fig. 25, and positioning the vise jaw (D) to the
desired angle. A scale (E) is positioned on the rear of
the table to give the proper cutting angle. lt may also be
necessary when angle cutting to move the left vise jaw
(F) to the rear to clear the blade guide bracket.
All manuals and user guides at all-guides.com
14 - English
C
B
A
Fig. 22
Fig. 23
B
A
Fig. 24
C
D
Fig. 25
C
A
F
E