HTW INNOVA HTWS026INNR32-INT Manual De Usuario E Instalacion página 44

Installation of indoor unit
Step 8: Bind up pipe
1. Bind up the connection pipe, power cord and drain hose with the band.
2. Reserve a certain length of drain hose and power cord for installation when binding
them.When binding to a certain degree, separate the indoor power and then separate
the drain hose.
Indoor unit
3. Bind them evenly.
4. The liquid pipe and gas pipe should be bound separately at the end.
NOTE:
● The power cord and control wire can't be crossed or winding.
● The drain hose should be bound at the bottom.
Step 9: Hang the indoor unit
1. Put the bound pipes in the wall pipe and then make them pass through the wall hole.
2. Hang the indoor unit on the wall-mounting frame.
3. Stuff the gap between pipes and wall hole with sealing gum.
4. Fix the wall pipe.
5. Check if the indoor unit is installed firmly and closed to the wall.
Indoor
Wall pipe
● Do not bend the drain hose too excessively in order to prevent blocking.
indoor and
outdoor power cord
gas
pipe
liquid pipe
band
drain hose
Outdoor
Sealing gum
connection pipe
indoor power cord
Lower hook of
wall-mounting frame
17
drain hose
band
Upper hook