Orascoptic EyeZoom Manual Del Usuario página 5

All manuals and user guides at all-guides.com
EyeZoom ™ and EyeZoom Mini
EyeZoom telescopes can transition magnification levels between 3x, 4x, and 5x power. EyeZoom Mini telescopes
can transition magnification levels between 2.5x and 3.5x power.
1. To change the magnification, grasp the black ridged portion
of each telescope and turn it so the arrow aligns with your
preferred magnification level (Figure 7).
2. Ensure both telescopes are set to the same power.
OmniOptic ™ Telescope System
Telescope anchors will be installed in the carrier lenses of your loupe frame.
1. Insert a matching pair of telescopes into the anchors and
they will be magnetically secured (Figure 8). Each telescope
is assembled with a key-slot to ensure it is properly aligned
in the anchor.
2. To remove telescopes from the anchors, hold onto the loupe
frame with one hand while pulling each telescope out of
its anchor. It will take reasonable force to disengage the
magnetic interface.
3. When your loose telescopes are not being used, they should
be stored in your loupe case.
ErgoEdge / RDH Elite Edge Frame
The ErgoEdge model frame employs a unique feature that allows you to add or subtract 5 degrees of declination (tilt) to
your telescopes. Three different angle settings are displayed on the inside of each temple arm where the arm interfaces
with the front of the frame.
1. From the optical laboratory, the declination of your
telescopes will be set to your prescribed angle and aligned
to the middle marking on each temple arm.
2. To change declination, loosen the angle control screw on
each temple arm and rotate the arms upward or downward
to align the arm with a different marking on the frame front,
then tighten the angle control screw to lock the temple
arm into that position (Figure 9).
• Top marking: increase declination (steeper angle)
• Bottom marking: decrease declination (shallower angle)
3. It is important that both temple arms are set to the same angle
or clear vision will be compromised.
4. The nose pad may need to be adjusted after changing
declination.
8
INSTRUCTIONS FOR USE
Orascoptic Loupes
Technical Support/Customer Care: 800.369.3698
Outside the U.S. or Canada Call Your Local Distributor
Figure 7
Figure 8
+5°
0°
Angle Control Screw
Figure 9
-5°