Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 Battery Pack Protection
To protect the battery pack from damage and extend
its life, the battery pack's V™-technology intelligent
circuit will turn OFF the battery pack if the current
draw becomes too high. This could happen in
extremely high torque, binding, stalling, and short
circuit situations. In these situations, the pump motor
will pulse for about 5 seconds before the battery pack
turns OFF.
To prevent the battery pack from turning OFF,
immediately reduce pressure on the application
or release the trigger. If the trigger is pulled after
the battery pack turns itself OFF, a clicking sound
(about once per second) will be heard and the pump
mechanism may rotate slightly. Place the battery pack
on the charger to reset the intelligent circuit and turn
the battery pack back ON.
5.3 Cold Weather Operation
The MILWAUKEE 28V Lithium-Ion battery pack can
be used in temperatures down to -4ºF [-15ºC]. When
the battery pack is very cold, it may pulse for the first
minute of use to warm itself up. Put the battery pack
on the pump and operate the pump under a light
load. After about a minute, the pack will have warmed
itself up and will operate normally. If the battery pack
is used too hard before it has warmed up, it may
"buzz" for 5 seconds and then turn itself OFF. Refer
to Section 5.2 for additional information.
5.4 Maintenance and Storage
Do not expose your battery pack or cordless Enerpac
pump to water or rain, or allow them to get wet. This
could damage the pump and battery pack. Do not
use oil or solvents to clean or lubricate your battery
pack. The plastic casing will become brittle and
crack, causing a risk of injury.
Store battery packs at room temperature away from
moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other battery
pack types, permanent capacity loss can result if the
pack is stored for long periods of time at temperatures
over 120ºF [49ºC]. MILWAUKEE Lithium-Ion battery
packs maintain their charge during storage longer
than other battery pack types. After about six months
of storage, charge the pack as normal.
WARNING: To reduce the risk of injury or
explosion, never burn or incinerate a battery
pack even if it is damaged, dead or completely
discharged. When burned, toxic fumes and materials
are created.
5.5 Battery Pack Disposal
Always dispose of all battery packs according
to federal, state and local regulations. Contact a
recycling agency in your area for recycling locations.
Refer to Section 5.6 for additional information on the
RBRC battery recycling program (USA and Canada
only).
Even discharged battery packs contain some energy.
Before disposing, use electrical tape to cover the
terminals to prevent the battery pack from shorting,
which could cause a fire or explosion.
5.6 R BRC Battery Recycling Program
(USA and Canada only)
The RBRC™ Battery Recycling Seals (see the
Symbology section earlier in this document) on the
28V Li-Ion battery pack indicate that MILWAUKEE
has arranged for the recycling of that battery pack
with the Rechargeable Battery Recycling Corporation
(RBRC). For more information about the RBRC, visit
the RBRC web site at www.rbrc.org.
At the end of the battery pack's useful life, take the
battery pack to an Enerpac Authorized Service Center
for recycling. If desired, the battery pack can also be
taken to a MILWAUKEE Branch Office/Service Center
or the participating MILWAUKEE retailer nearest you.
6.0 CHARGER OPERATION
WARNING: Charge only MILWAUKEE 28V
Lithium -Ion battery packs in the MILWAUKEE
Li-Ion Battery Charger. Other types of batteries may
cause personal injury and damage.
6.1 When to Charge the Battery Pack
Remove the battery pack from the pump for
charging when it is convenient for you and your
job. MILWAUKEE Lithium-Ion battery packs do not
develop a "memory" when charged after only a partial
discharge. It is not necessary to run down the battery
pack before placing it on the charger.
• Use the Fuel Gauge to determine when to charge
your Li-Ion battery pack.
• You can "Top-Off" your battery pack's charge before
starting a big job or long day of use.
• It is only necessary to charge your Li-Ion battery
pack when the pack has reached the end of its
charge. To signal the end of charge, power to the
pump will drop quickly. Charge the battery pack as
needed.
6.2 How to Charge the Battery Pack
Place the battery pack onto the bay by sliding the
pack on from the top of the bay. The red light will
come on, either flashing (pack is too hot or cold) or
continuous (pack is charging).
• The Fuel Gauge lights on the Li-Ion battery pack are
displayed as the pack is being charged, indicating
the relative amount of charge.
• A fully discharged Li-Ion pack with an internal
temperature in the normal range between 32ºF and
150ºF [0ºC to 65ºC] will charge in about an hour.
Heavily cycled battery packs may take longer to
charge completely.
• After charging is complete, the continuous green
light will come on and the Fuel Gauge lights will go
off. The Fuel Gauge button won't work when the
pack is on the charger.
• The charger will keep the battery pack fully charged
if it is left on the charger.
4
Publicidad
