Waeco PerfectView CAM26W Instrucciones De Montaje Y Uso página 35

_RV-26.book Seite 35 Montag, 7. Mai 2007 2:28 14
PerfectView CAM26W
If you want to screw on the camera with self-tapping screws
(fig. f, page 7)
Caution!
a
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 4.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 6 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig. g, page 7)
Caution!
a
Ensure that that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M6 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig. h, page 7)
Note!
I
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 20 mm diameter.
Check beforehand that there is sufficient room for the drill
head to come out on the other side.
➤ Drill a hole of Ø 20 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
All manuals and user guides at all-guides.com
Mounting the camera
35