3M DBI SALA NANO-LOCK 3100273 Manual Del Usuario página 16

5.0 INSPECTION
;
After equipment has been removed from service, it may not be returned to service until a Competent Person has
confirmed in writing that it is acceptable to do so.
5.1 INSPECTION FREQUENCY: The product shall be inspected by the user before each use and, additionally, by a
Competent Person other than the user at intervals of no longer than one year. A higher frequency of equipment use
and harsher conditions may require increasing the frequency of Competent Person inspections. The frequency of these
inspections should be determined by the Competent Person per the specific conditions of the worksite.
5.2 INSPECTION PROCEDURES: Inspect this product per the procedures listed in the "Inspection and Maintenance Log".
Documentation of each inspection should be maintained by the owner of this equipment. An inspection and maintenance
log should be placed near the product or be otherwise easily accessible to users. It is recommended that the product is
marked with the date of next or last inspection.
5.3 DEFECTS: If the Connected Order Picker System cannot be returned to service because of an existing defect or unsafe
condition, then either destroy the system or contact 3M about replacement or repair.
5.4 PRODUCT LIFE: The functional life of the Connected Order Picker System is determined by work conditions and
maintenance. As long as each component of the Connected Order Picker System passes inspection criteria, the system
may remain in service.
6.0 MAINTENANCE, SERVICE, and STORAGE
;
Equipment that is in need of maintenance or scheduled for maintenance should be tagged "DO NOT USE". These
equipment tags should not be removed until maintenance is performed.
6.1 CLEANING: Periodically clean the Connected Order Picker System's metal components with a soft brush, warm water,
and a mild soap solution. Ensure parts are thoroughly rinsed with clean water.
Cleaning procedures for the SRD are as follows:
• Periodically clean the exterior of the SRD using water and a mild soap solution. Position the SRD so excess water can
drain out. Clean labels as required.
• Clean the Lifeline with water and a mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat. The
lifeline should be dry before allowing it to retract into the housing. An excessive buildup of dirt, paint, etc. may prevent
the lifeline from fully retracting back into the housing causing a potential free fall hazard.
6.2 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment.
6.3 STORAGE AND TRANSPORT: When not in use, store and transport the components of the Connected Order Picker
System in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly
inspect components after extended storage.
7.0 LABELS and MARKINGS
7.1 LABELS: Figure 13 illustrates labels on the Connected Order Picker System and their locations. All labels must be present
on the system. Labels must be replaced if they are missing or are not fully legible.
1) Company Contact Information
2) Manufactured (Year/Month)
A
3) Lot Number
4) Model Number
5) Length (ft./m)
1) Company Contact Information
2) Manufactured (Year/Month)
B
3) Lot Number
4) Model Number
5) Length (ft./m)
C
1) Company Logo
D
1) Anchor above D-ring during use. 2) Read all instructions. 3) Translated label
E
1) Warning - Read all instructions. 2) Translated warning
1) Manufacturing Date
F
2) Lot Number
3) Manufacturing ID
1) Manufacturing Number
2) Maximum Arresting Force
G
3) FCC ID Number
4) IC Number
1) Power Indicator and Bluetooth Indicator
2) Manufactured (Year/Month)
H
3) Lot Number
4) Model Number
5) FCC ID Number and IC Number
16