First Time Use; Microwave Cooking; Setting The Clock - Danby DDMW01440WG1 Manual Del Propietário

OPERATING INSTRUCTIONS

FIRST TIME USE

When the microwave is plugged in for the fi rst time
it will beep and the display will show "1:01" and
"CLOCK". Use the number pad to enter the current
time and then press the clock button to confi rm.
When setting the cook timer, the microwave will
return to standby mode if there is no input within 25
seconds.
During operation:
• Press the Start/+30SEC button to begin
operation.
• Press the Stop/Clear button once to pause a
program and twice to cancel a program.
• The microwave will beep four times and display
"END" at the end of a cooking program. The
microwave will continue to beep every two
minutes until the door is opened or the Stop/
Clear button is pressed.

SETTING THE CLOCK

The clock can be set as a 12 or 24 hour clock. Press
and hold the Clock/Timer button for 3 seconds
to choose a 12 hour clock, then press it again to
choose a 24 hour clock.
To set the current time:
1. Press the Clock/Timer button.
2. Use the number pad to enter the current time.
3. Press the Clock/Timer button to confi rm.
During operation, press the Clock/Timer button to
see the current time.
Note: If the set time exceeds the allowable range,
the microwave will return to reset state after
pressing the Clock/Timer button.

MICROWAVE COOKING

1. Press the Power button repeatedly to select the
power level.
2. Use the number pad to enter the desired cooking
time. The maximum time is 99 minutes and 99
seconds.
3. Press the Start/+30SEC button to begin
operation.
Press Power Button
Once
Twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
Note: If "PL0" is selected, the microwave fan will
run with no cooking function. This power level can
be used to remove odors from the oven.
Note: During cooking, press the Power button to
check the current power level.
11
Power (Display)
100% (P-100)
90% (P-90)
80% (P-80)
70% (P-70)
60% (P-60)
50% (P-50)
40% (P-40)
30% (P-30)
20% (P-20)
10% (P-10)
0% (P-00)