VONROC PS502DC Traducción Del Manual Original página 9

The charger has 2 LED indicators (13) which indicate
the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
4. OPERATION
Switching on and off (Fig. A)
• To switch on the machine, press the on/off
switch (1) into position I.
• To switch off the machine, press the on/off
switch (1) into position 0.
Hints for optimum use
• Firmly hold the machine with both hands.
• Switch on the machine.
• Place the sanding pad with sanding paper on
the workpiece.
• Slowly move the machine over the workpiece,
firmly pressing the sanding pad against the
workpiece.
• Do not apply too much pressure on the machine.
Let the machine do the work.
WWW.VONROC.COM
5. MAINTENANCE
Charger status
No power
Standby mode:
Clean the machine casings regularly with a soft
- No battery is
cloth, preferably after each use. Make sure that
inserted or,
the ventilation openings are free of dust and
- Battery inserted
dirt. Remove very persistent dirt using a soft
but charging has
cloth moistened with soapsuds. Do not use any
finished
solvents such as gasoline, alcohol, ammonia, etc.
Battery charging in
Chemicals such as these will damage the synthetic
progress
components.
ENVIRONMENT
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
EN
9