Programming - Saeco au Lika SUP040R Manual Del Usuario

Machine Installation - Service Provider Manual
Warning! Do NOT overturn the machine for kit
installation.
2 (Fig.3) - Unscrew the lower back carter holding screws.
(Fig.4) - Identify the cap containing the connection fi ttings.
3
4 (Fig.5) - Unscrew the cap holding screw.
5 (Fig.6-7) - Manually remove the cap by making it slide
outward and pulling it downward.
6 (Fig.8) - Separate the electrical connector from the terminal
board.
7 (Fig.9) - Remove the fi ttings joining the braided hose to the
transparent silicone hose.
8 (Fig.10) - First insert the clamp, then the fi tting in the
braided hose. Lock the hose by tightening the clamp.
(Fig.11) - Insert the supplied braided hose into the fi tting
9
and lock it with the clamp.
10 (Fig.12) - Insert the other fi tting in the transparent silicone
hose sticking out from the machine .
11 (Fig.13) - Insert the supplied transparent silicone hose into
the fi tting.
12 (Fig.14) - Insert the supplied transparent silicone hose into
the pressure reducer lower fi tting.
13 (Fig.15) - Insert the clamp in the braided hose. Insert the
braided hose in the pressure reducer upper fi tting, then lock the
hose with the clamp.
(Fig.16) - Join the electrical connector sticking out from
14
the machine to the one supplied with the kit; pay attention to
insert it correctly.
15 (Fig.17-18) - Insert the protection element with the reducer
in the machine: fi rst insert the reducer on the machine side, then
bring it back to its original position.
16 (Fig.19) - Fix the protection element with the screw already
available on the machine.
• 10 •
17 (Fig.20-21) - Remove the protection cap and connect the
hose to the water network (not supplied).
Check hose and gasket sealing before connecting to the mains.
Make sure to identify the data plate upon the
outer side of the back lid. Data plate must be
provided in compliance with the applicable safety
regulation. Should it be missing, contact the Service to
proceed with prompt adjustment.
3

PROGRAMMING

After installing the kit, proceed with software activation in order
to ensure the correct management of the machine phases.
1 Access machine programming as described in the 9.1 section
of the supplied manual.
MENU
CREDITS MENU
BEVERAGE MENU
MACHINE MENU
2 To select the "MACHINE MENU" option, press the "
button (24).
MENU
CREDITS MENU
BEVERAGE MENU
MACHINE MENU
3 Press the " " button (18) to access.
MACHINE MENU
GENERAL MENU
DISPLAY MENU
WATER MENU
MAINTENANCE
4 Press the " " button (24) until the "WATER MENU"
option can be selected.
MACHINE MENU
GENERAL MENU
DISPLAY MENU
WATER MENU
MAINTENANCE
"