Waterpik WP-100 Serie Manual Del Usuario página 7

Prime Unit (First Time Use Only)
Set pressure control dial on base to high, point the
handle and tip into sink. Turn unit ON until water
flows from the tip, turn unit OFF.
ON
High
Adjusting the Pressure Setting
Turn the pressure control
dial on the base of the
unit to the lowest setting
(pressure setting No.1) for
first-time use. Gradually
increase pressure over
time to the setting you prefer – or as instructed by
your dental professional.
Using the Water Flosser
Always place the tip in your mouth before
turning the water ON. Lean over sink
and slightly close lips enough to prevent
splashing while still allowing water to flow
from mouth into the sink.
Turn power ON. When finished,
turn power OFF.
All manuals and user guides at all-guides.com
During use you can
temporarily stop water flow by
pressing the pause button on
the handle.
NOTE: Motor will continue
to run.
Recommended Technique
For best results,
start with back teeth
and work toward the
front teeth. Direct the
stream at a 90-degree angle to your gumline with
tip in mouth. Glide tip along gumline and pause
Low
briefly between teeth. Continue until you have
cleaned the inside and outside of both the upper
and lower teeth. Lean over sink.
When Finished
Turn the unit off. Empty any liquid left in the
reservoir.
Note: If you used mouthwash or other solution
besides water, see "Using Mouthwash and Other
Solutions" section.
7
Pause