bloom alma urban Manual Del Usuario página 10

eng
COT SHOULD BE ADJUSTED TO THE LOWEST
POSITION BEFORE THE CHILD CAN SIT UP.
WARNING:
To prevent injury from falls, the cot shall no longer
be used if child is able to climb out of cot.
3 - 14 Cot Set Up
– (#01 cot frame) Fully extend the cot frame by
pulling end panels outward.
– (#02 base board) Place the base board within
the cot frame, onto the stays. Make sure
correct side up – the side with labels is the
top side of base board. There are dowel pins
on the base board stays which will align with
the holes in the base board to allow correct
placement.
– Lock the clasps on both ends of the base
board, check the clasps are firmly locked and
the base board should be both secure and
perfectly flat.
– (#03 side stays, #04 end stays, #05 tool – hex
key, #06 blots) To change base board level -
remove all 6 base board stays from the frame
(side stays x 4 + end stays x 2) by loosening
the bolts using the tool included (#05 hex key).
You will find the hex key enclosed with the
castors.
– Assemble the 6 base board stays to your
desired base board level. Secure by tightening
the bolts with tool included (hex key). Make
sure the stays are assembled correct side up.
(refer to illustration 12)
– Please store the tool (hex key) in safe place for
future use.
10
All manuals and user guides at all-guides.com
– The cot assembly is now complete.
Mattress
– Mattress is not included with the cot/crib. This
can be purchased separately. Always use a
mattress with your cot/crib.
– Minimum size of mattress to be used with the
alma cot should be 90cm / 35½" x 45cm /
17¾", and the gap between the mattress and
the sides and ends must not exceed 3cm / 1¼".
– Mattress thickness shall not exceed the level
marks " " indicated on the inner facing of the
side panel for both base board heights (refer
to illustration 8 & 14). Thickness of the mattress
shall be such that the internal height (surface
of the mattress to the upper edge of the cot
frame) is at least 50cm / 19¾" in the lowest
position of the cot base and at least 20cm /
7¾" in the highest position of the cot base.
– Using the wrong size mattress may create
hazardous gaps that could result in
suffocation or could reduce the side height of
the cot which may result in your child falling
out from the cot.
15 - 16 Storage
– To fold away your alma cot for storage, first
remove mattress.
– Remove base board from frame – unlock the
clasps on both ends of the base board by
sliding buttons inward.
– Fold side panels inwards and push end
panels in together. Make sure the panels
are folded in the correct direction. (refer to
illustration 16)