Seav LR 2329 Serie Manual Del Usuario página 11

pliance with the Machinery Directive
and with EN 12604.
2) Check that the location where the
installation is located enables com-
pliance with operating temperature
limits specified for the device.
3) The safety of the final installation
and compliance with all prescribed
Standards (EN 12453 - EN 12445) is
the responsibility of the person who
assembles the various parts to con-
struct a total closing.
4) Use safety devices capable of moni-
toring the status of their connection
to the electrical control unit.
5) Once installation is finished, it is
recommended that all necessary
checks be performed (appropriate
programming of the control panel and
correct installation of safety devices)
to ensure that compliant installation
has been performed.
6) Fix the control unit to a wall, using
the relevant support which is fitted to
the casing, in such a way as to leave
said support facing downwards and
insert the fixing screws in the specific
holes.
7) The control unit does not have any
type of disconnecting device for the
230 Vac line. It is therefore the re-
sponsibility of the installer to set up
a disconnecting device inside the sy-
stem. It is necessary to install an om-
nipolar switch, surge category III. It
must be positioned to provide protec-
tion from accidental closing, pursuant
to point 5.2.9 of EN 12453.
8) Cables for power and connection to
the motor suitable for insertion in the
11