Seav LR 2329 Serie Manual Del Usuario página 16

of a radio control saved earlier, for more than 3 seconds. The control unit will then emit 3
short confirmation BEEPS. Press the normal operation button of the same remote control
for more than 3 seconds, the control unit will emit another 3 short confirmation BEEPS.
Lastly, press the radio control button to be saved for more than 3 seconds, the control unit
will send 4 short BEEPS, thereby signalling the exit from the remote programming mode.
Deleting the Radio Controls:
Proceed as follows to delete all the Radio Controls saved: press the PROG button until the
control unit emits a series of three short and then two long acoustic signals, indicating
the launch of the programming stage and the deletion of all the radio controls saved. The
control unit will remain in programming mode for about 10 sec., after which it will exit
autonomously by emitting four short beeps.
Maximum number of remote controls that can be saved:
The control unit can save up to 120 Radio Controls with different codes. If the maxi-
mum number of radio controls that can be saved has been reached, by repeating the
programming operation, the control unit highlights the failure: the LED CODE does not
flash, remaining on steady and emitting a long acoustic signal. The control unit will then
send 4 short beeps, signalling the exit from the programming mode.
RESET (applies to Motor and Pause Time only):
If it is best to restore all the Motor and Pause times to the factory values, set DIP 1, DIP 2,
DIP 3, DIP 4 and DIP 5 to ON. At the same time, press the PROG key until the control unit
emits a series of three short and then three long acoustic signals, indicating the launch of
the programming and the deletion of all the times saved. Then set back DIP 1, DIP2, DIP
3, DIP 4 and DIP 5 = OFF to end the operation.
DIAGNOSTICS:
Control input test:
On each low voltage control input, the control unit uses an LED signal to make the status
readily known.
Operating logic: when an LED is on it means the input is closed, when an LED is off it
means the input is open.
Rev. 1.4 04/05/2020
16