Honeywell CL202PEU Manual De Instrucciones página 8

USE & OPERATION (CONTINUED)
CLEANING THE HONEYCOMB COOLING MEDIA
Switch off the master power for the outlet before unplugging the unit from the electrical outlet.
Make sure all outlets and plugs are dry before use.
•
The appliance is supplied with a Honeycomb Cooling Media.
• Honeycomb Cooling Media is located inside the Rear Grill. See Figure 1 for instructions on
how to remove them from the unit for cleaning and maintenance.
• Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
•
The cleaning frequency for the Honeycomb media depends on local air and water conditions.
In areas where the mineral content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with
fresh water at least once a week will help reduce mineral deposits. If mineral deposits remain
on the Honeycomb Cooling Media, the media should be removed and washed under fresh
water. The media should be cleaned every two months or sooner, depending on your needs.
•
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the
cool function 15 minutes before turning the unit off.
Removing the Honeycomb Cooling Media:
1. Remove all the screws from the Rear Grill of the Air
Cooler.
2. Carefully pull out the rear grill from the cooler.
3. Remove the screws on the base of the Honeycomb
Frame and slide out the Honeycomb Cooling
media. Replace or clean media with water and a
damp cloth as needed.
WARNING: DO NOT operate the Air Cooler when the Rear
Grill is removed from the Air Cooler, or if there is a loose-fitting
Rear Grill. Doing so can cause serious injury or dangerous
electrical shock.
Figure 1:
EN 7
Honeycomb
Cooling Media
Honeycomb
Frame
Screws
Rear Grill