Special maintenance
Any special maintenance operation must be carried out at an Authorized Service Point.
AUTHORIZED SERVICE POINT
It is the Service Point authorized by the Manufacturer for repairing the products.
Periodic maintenance table
Check chain lubrication.
Check the condition and tension of the chain.
Check the condition of the bar.
Check the efficiency of the safety catches and protections.
Check and top up the oil
Remove cutting residues.
Check the chain pinion for wear.
Battery holding recharge. Necessary to prevent it from dropping below
15V (no longer rechargeable).
Overhaul to be carried out at a Manufacturer's Authorised Assistance
Centre.
7 DISMANTLING THE TOOL WHEN NO LONGER USED
Disposal of exhaust materials
After having been installed and during use, the machine does not cause any environmental pollution. However,
throughout its working life, some types of residual waste or exhaust materials, such as the lubricants for the
mechanical components, are being produced in certain maintenance situations.
There are specific regulations in every Country as for the disposal of these materials and the environment
protection. The Customer is required to be knowledgeable in the Laws in force in his own Country and to oper-
ate only while complying with these regulations, according to the indications in the product technical charts,
which may be obtained from the Manufacturer.
The Laws in force about the disposal of mineral oils or greases used for the lubrication / maintenance opera-
tions must be followed.
More information about the disposal of oils and other substances can be found in the safety chart of the sub-
stances.
The steps employed in the disposal of toxic waste including the collecting, transporting, processing (transfor-
mation for recycling), as well as the deposit and the dumping onto the ground are all usual activities of common
interest and are subject to the following general principles:
a)
Any risks of injuries or dangers for the health and safety of any individual and of the community
have to be avoided.
b)
Compliance with any and all hygienic-sanitary requirement and avoidance of any air, water,
ground and underground pollution have to be guaranteed.
Use and maintenance manual – Translation of
original Instruction.: 01, Date 24/11/2021
MAINTENANCE
ROUTINE
EXTRAORDINARY
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Page 43