Air Flow Direction Adjustment - Hiyasu ASE 7TB Manual De Funcionamiento

06Manual 3Hiyasu Eng 7/4/06

(5) Air flow direction adjustment

After operation mode is selected, vertical flap will open automatically according to the mode.
Referring to the Fig.
COOL
About 10º
Up and down (Use remote controller)
Press SWING button, vertical flap will move within
the range shown in the Fig. Press SWING button
stop it at a fixed position.
About 10º
COOL About 45º
HEAT About 60º
Cautions:
It is advisable not to keep vertical flap at downward posi-
tion for a long time in COOL or DRY mode, otherwise,
condensate water might occur.
(6) Unit stop
Press ON/OFF button.
Only time remains on LCD.
All indicators on indoor unit go out.
Vertical flap closes automatically.
Hints
As cold air flows downward in COOL mode, adjusting air flow horizontally will be much more helpful for a better air circulation.
As warm air flows upward in HEAT mode, adjusting air flow downward will be much more helpful for a better air circulation.
Be careful not to catch a cold when cold air blows downward.
It is harmful to your health in summer to go frequently in and out of places where temp.
difference is above 7
More than this, unit's load can be reduced and power consumption cut down as well. So, you'd better set a temp. difference
of 3-5 o C between indoor and outdoor temp. in COOL mode.
09:28 Página 53
OPERATION
o C. Temp. difference of 3-5 o C will remove your fatigue.
HEAT
About 60º
Left and right air flow adjustment
(manual)
Move the horizontal blade by a knob on air
conditioner to adjust left and right direction
referring to Fig.
Cautions:
When humidity is high, condensate water might occur
at air outlet if all horizontal louvers are adjusted to left
or right.
Cautions:
Unit won't restart until 3 minutes have elapsed, due to
system protection.
HEAT mode is not available on cooling only unit.
53