FLAEM NebulFlaem 4.0 CONDOR F2000 Manual De Instrucciones página 6

Select the desired position by means of the particle size regulator C1.1.
By turning the regulator clockwise, the selector (C1.1c) moves and closes the opening, while it opens if the regulator is
turned anti-clockwise.
To use the bowl without selector, firmly grasp the bowl body and use your other hand to rotate the particle size regula-
tor (C1.1) clockwise until it is ejected from the upper part (C1.2).
INSTRUCTIONS FOR USE
Before each use, clean hands thoroughly and clean the device as described in the section on "CLEANING
SANITISATION DISINFECTION". During use, it is advisable to protect yourself from any dripping. It is
recommended that each person use their own nebulizer cup and accessories to prevent risk of infection due to
contamination.
This device is suitable for the administration of medical substances and not, for which the administration via aer-
osol is foreseen; these substances are to be in any case prescribed by the Doctor. In case of too thick substances,
the dilution with a suitable physiological solution could be needed, according to the medical prescription.
1. Plug the power cord (A7) into a power socket corresponding to the voltage of the unit. This must be positioned so
that it is not difficult to make the disconnection from the mains.
2. Pour the medication prescribed by the physician into the lower part (C1.4). Insert the upper part(C1.1+C1.2+C1.3)
of the bowl into the lower part (C1.4), then close the bowl by turning the upper part (C1.2) clockwise. Close the
nebulizer by turning the upper part (C1.2) clockwise.
3. Connect accessories as indicated in the "Connection diagram" on the cover.
4. Set the bowl selector to the desired particle size as described under "HOW TO USE THE
RF9 NEBULIZER WITH PARTICLE SIZE REGULATOR AND VALVE SYSTEM".
5. Sit comfortably holding the nebulizer in your hand, place the mouthpiece onto your
mouth or alternatively use the nose piece or mask. Should you opt for the mask
accessory, place it on your face as shown in the picture (with or without using the
elasticated strap).
6. Start the device by operating the switch (A1). Inhale gently and deeply; after inspiration
we recommend to hold your breath for a moment in order to allow inhaled aerosol
droplets to deposit. Then, exhale slowly.
7. When the treatment is finished, shut off the device and unplug the power cord.
WARNING: If after the therapy session moisture accumulates in the tube (B), remove the tube from the nebulizer and
dry it using the device's compressor fan; this operation will prevent mold from forming inside the tube.
-
+
C1.1
C1.2
4