Canopy Assembly; Important; Remote Control - Craftmade Fluid FLD54 Guia De Instalacion

9. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and partially loosen both screws.
Lift canopy to hanging bracket. Place
rounded part of slotted holes in canopy
over loosened screws in hanging bracket
and push up. Twist canopy to lock and then
tighten both screws securely.
*Remember that antenna for remote
control receiver must rest outside of
hanging bracket.
10. Automated Learning Process./Activating Code.
Install one battery in transmitter and one in
wall control (if applicable). [Batteries are
included.]
IMPORTANT: Remote/wall control will not
function unless battery is installed.
CAUTION: Store the transmitter away from
excess heat or humidity. To prevent
damage to transmitter, remove the battery
if not used for long periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES
IN FIRE, BATTERIES MAY EXPLODE OR LEAK."
- When disposing of household alkaline
batteries, it is best to check with your local
and state recycling or household
hazardous waste coordinators concerning
the specifics of the program in your area.
You may also locate a recycling center by
calling 1-800-8-BATTERY or
1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts.
Keep battery away from children.
antenna
screw

REMOTE CONTROL

(lower portion)
WALL CONTROL
(lower portion)
page 7
hanging bracket
screw
canopy
LEARN
BUTTON
BATTERY
COMPARTMENT
LEARN
BUTTON
BATTERY
COMPARTMENT