Automated Learning Process; Testing Your Fan - Craftmade Fluid FLD54 Guia De Instalacion

10. Automated Learning Process./Activating Code. (cont.)
REMOTE
CONTROL
LED LIGHT
FAN OFF
3 4
2
FAN SPEED
1
REVERSE
FACEPLATE
LED LIGHT:
FAN SPEED, Buttons 1-6:
REVERSE:
LEARN button:
FAN OFF:
ON/OFF slider switch:
Select faceplate for remote control and/or wall control and press firmly onto front of remote control and/or wall
control.
IMPORTANT: The Automated Learning Process takes 5 minutes to complete. Please leave the fan "on"
for the duration of the 5-minute programming and DO NOT use the remote control during
this time.

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to
ON position. Test fan speeds. Next, locate remote control
transmitter. Test fan speed with different fan speed
buttons (1 - 6). If the remote control operates the functions
of the fan, battery has been installed correctly. If the wall
and/or remote control do (does) not operate the fan
functions, refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Fan must be on LOW before setting the fan in reverse. Use
the button to recirculate air depending on the season.
A ceiling fan will allow you to raise your thermostat setting
in summer and lower your thermostat setting in winter
without feeling a difference in your comfort.
IMPORTANT: Remote control (and wall control, if
applicable) must be synchronized with fan in order to
properly function.
IMPORTANT
LEARN
Remote and wall
BUTTON
5 controls must be
6
SYNC R ONI E with
fan in order to
properly function.
Lights up when any button is pressed.
Use to control the ceiling fan speed 1-6.
Use to control fan direction.
Turn fan power on. Within 30 seconds of powering fan, press and hold
LEARN button on remote control and/or wall control for 5 seconds (or
until fan beeps twice) in order to synchronize remotes with fan motor.
Use to turn fan off.
[Wall control only] Use to turn wall control on or off.
page 8
WALL
CONTROL
LED LIGHT
3 4
2
5
1
6
12V
3 4
5
2
1
6
FAN OFF
FAN SPEED
REVERSE
LEARN
BUTTON
ON/OFF
SLIDER
SWITCH