Bahco BBL12-400 Manual Del Usuario página 9

PROBLEM
The unit won't jump start
my car.
The unit won't power my 12V
or USB device.
The display shows JUMP
START READY-BATTERY
COLD REDUCED
PERFORMANCE.
Beeping sound and display
shows BATTERY LOW-
RECHARGE.
The green LED is flashing
and the display shows
CHARGE ABORTED-SEE
MANUAL.
13. SPECIFICATIONS
Internal battery type .............................................. Lithium Iron Phosphate (Lithium Ion)
Chargers ..........................................................100V~240V / 50-60 Hz. AC wall charger
Capacity .........................................................................................12,000 mAh/38.4 Wh
12V DC power output.................................................................................................. 6A
USB output......................................................................................................5V DC, 2A
Jump start .............................................................................................................400CA
Light ................................................................................................................1W/90 Lm
Overload protection................................................................................................... Yes
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
Clamps are not making a good connection
to the battery.
The internal battery is not charged.
The temperature of the internal battery is
above 55°C (131°F).
The vehicle's battery voltage is over 15V.
The vehicle's battery voltage is below 1V.
The outside temperature is less than
-10°C (14°F).
The vehicle's battery is defective.
The device is not turned on.
The internal battery is not charged.
The temperature of the jump starter's
internal battery is too low.
The internal battery was discharged,
when using the 12V/USB function.
The internal battery was dicharged, when
using the jump starter.
Charging has aborted. The battery is not
accepting a charge.
Check for poor connection to battery and
frame. Make sure connection points are
clean.
Check the battery charge status and
recharge, if necessary.
Place the unit in a well-ventilated area, to
cool the battery.
You cannot use this jump starter for this
vehicle.
Press and hold jump start button for
5 seconds, until display shows JUMP
START READY.
Try starting several times. If not
successful, place the unit in a warmer
area for a short time.
Have the battery checked.
Turn on the device.
Check the battery charge status and
recharge, if necessary.
Turn on the headlights or try to jump
start a few times, to warm up the internal
battery of the jump starter.
If battery is not recharged, 12V/USB will
shut off after 10 minutes.
Recharge the internal battery.
Reset the charger by briefly unplugging
the unit. If problem persists, call
customer service.
• 9 •
REASON/SOLUTION
12V DC car charger