Sony ZS-2000 Manual De Instrucciones página 17

On the remote
1 Press BAND to select
the band.
2 Press TUNE + or – to
set the frequency to
the station you want.
3 Press and hold the
number button that
you want to preset
the new station on
for 2 seconds.
Tip
When receiving RDS
broadcasts, "PS"
appears in the display
at the time of labelling
(page 20). Change the
name according to step
6, if necessary, then
press DISPLAY•
ENTER MEM.
If a station cannot be preset automatically
You need to preset a station with a weak signal
manually. You can also label the preset station.
1 Press RADIO BAND•AUTO PRESET to select the
band.
2 Tune in a station you want.
3 Hold down DISPLAY•ENTER MEM for 2 seconds
until the preset number flashes in the display.
4 Press PRESET + or – until the preset number (1 to
10) you want for the station flashes in the display.
5 Press DISPLAY•ENTER MEM.
6 Input the name of the station (up to 8 characters).
1 Select a character by pressing TEXT + or –.
2 Press CURSOR t to make the cursor shift
rightward.
Repeat steps 1 and 2.
You can also use the following buttons:
Button to use
CURSOR T, t
CHARACTER
7 Press DISPLAY•ENTER MEM.
Function
Move the cursor leftward or
rightward
Each time you press the button,
the character changes as follows:
Upper case letters t
Lower case letters t
Numbers and symbols.
GB
17
The Radio