Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1. Remove the hanger ball
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 7. (Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
3. Loosen the two set screws in the downrod support
of the motor assembly. Route the black, white and blue
wires through the downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through the motor coupling cover and
assemble the coupler to the motor assembly using the
All manuals and user guides at all-guides.com
portion
from the downrod/
6
Downrod
Set Screw
Figure 1
Hairpin
Clip
Figure 2
Figure 3
Hairpin Clip
Figure 4
3/16 -24 x 3/8
Pan Head Screw
with Lock Washer
Motor
Assembly
Figure 5
HARDWARE USED:
3/16 -24 x 3/8
SCREWS
Pin
Hanger Ball
Clevis Pin
Black, White and
Blue Leads
Downrod
Downrod
Set Screws and
Motor Coupling
Cover
x 3
Publicidad
