Changing The Filter - Bosch BSG4 Serie Instrucciones De Uso

en

Changing the filter

Replacing the dust bag
Figure 15*
If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the highest
suction power is selected, the dust bag must be
changed, even though it may not yet be full. In this case
it is essential to change the dust bag due to the type of
material it contains.
The nozzle, suction pipe and flexible tube must not be
blocked, as this would also lead to dust bag change
indicator being triggered.
Figure 16
Open the lid by moving the locking lever in the direction
of the arrow.
Figure 17
a) Seal the dust bag by pulling the sealing strip and then
remove it.
b) Slide the new dust bag into the holder to the stop.
!
Caution: The cover can only be closed when
a dust bag is inserted.
If you have used the vacuum cleaner for fine dust
particles (such as plaster or cement), clean the motor
protection filter and, if necessary, replace the microfilter.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Illustration 18*
Open the dust bag compartment lid.
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter
should be rinsed.
The filter must then be left to dry for at least 24 hours.
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
*Depending on version
8
All manuals and user guides at all-guides.com
Care
!
Subject to technical changes.
Always switch the vacuum cleaner off and disconnect the
power cord from the mains before cleaning the vacuum
cleaner.
The vacuum cleaner and plastic accessories can be
cleaned with a commercial plastics cleaner.
Do not use abrasive, glass or all-purpose cleaners.
Never immerse the vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with
a second vacuum cleaner or simply wiped with a dry
cloth or a duster.