Electrical Operation; Battery Operation - Medela Pump In Style Advanced Manual De Instrucciones

Assembly Instructions
lV
4
5
6
7

Electrical operation

8a

Battery operation

8b
The Battery Pak uses 10 AA alkaline or rechargeable batteries. Each set of batteries will provide
approximately 2 hours of pumping time. It is recommended that batteries be replaced or
recharged between the 10th and 12th pumping session.
4 EN
All manuals and user guides at all-guides.com
+
j k l m
j k
+
l m
a
Insert other ends of tubing into ports on diaphragm cap.
Remove tubing by grasping the ends and twisting until tapered ends
loosen.
NOTE: Do not remove tubing by forcefully pulling the tube or pulling
at an angle.
• If single pumping, insert port plug into the unused port.
• If double pumping, push port plug onto post.
Plug the electrical connector on the end of mains adapter or Battery
Pak cord into power jack on breastpump.
Plug the mains adapter into a standard electrical outlet.
Slide off battery covers. Insert the batteries in the correct position as
indicated inside the Battery Pak. Push the battery in and down in one
motion until the battery snaps into place. Five batteries must be inserted on
each side of the Battery Pak. Replace battery covers. The Battery Pak was
designed for safe use while stored in its pouch. The pouch fits inside the
main bag or motor bag, along with the mains adapter. Or for easier access,
the velcro strap allows for attachment to the pump shoulder strap.
Screw bottles into breastshields.
a
Insert hard adapter ends of tubing into
openings in breastshields.
h