Machine Setup; Attaching Squeegee Assembly - Nobles Speed Scrub 1710 Plus Manual Del Usuario

OPERATION
5. After connecting cables to bottom battery, carefully
hang metal battery tray on studs located above
bottom battery. Place top battery into tray with
posts positioned towards rear of machine. Secure
top battery with strap (Figure 3).
FIG. 3
6. Connect black battery cable coming from machine
to negative (–) post of top battery. Then connect
opposite end of black jumper cable to positive (+)
post (Figure 4).
(–)
Black
Cable
(–)
Jumper
Cable
FIG. 4
7. Reconnect vacuum hose to recovery tank snout
as shown (Figure 5).
FIG. 5
8
All manuals and user guides at all-guides.com
8. After batteries are properly installed, turn on key

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

(+)
Jumper
1. Turn key to the off position.
Cable
FOR SAFETY: Before leaving or servicing
TOP
machine, stop on level surface and turn off
BATTERY
machine.
2. Raise squeegee mount bracket by moving
(+)
Red Cable
BOTTOM
BATTERY
3. Loosen two thumb knobs on squeegee assembly
and vacuum switch and check battery meter
charge level. Charge if necessary (See BATTERY
CHARGING) (Figure 6).
FIG. 6
squeegee lift knob to the left (Figure 7).
FIG. 7
and slide squeegee into slots on squeegee mount
bracket (Figure 8).
Speed Scrubt 1701 Plus (02–04)