Operating Accessory Tools (Optional); Circuit Breakers; Machine Adjustments; Adjusting Solution Flow - Nobles Speed Scrub 1710 Plus Manual Del Usuario

ATTENTION: Do not operate machine with battery
meter in red zone, battery damage will result.
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
10. On last scrubbing pass, turn off solution switch
just prior to stopping machine. This will allow total
recovery pick up.
11. When solution tank runs dry, drain recovery tank
(See DRAINING TANKS).

OPERATING ACCESSORY TOOLS (OPTIONAL)

1. Attach accessory solution hose to quick coupler.
2. Disconnect squeegee hose from inlet tube and
replace with accessory vacuum hose.
3. Connect hoses to wand.
4. Turn on key, wand pump and vacuum switches
(Figure 26).
FIG. 26
5. Operate accessory tool as normal.
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
Speed Scrubt 1701 Plus (02–04)
All manuals and user guides at all-guides.com

CIRCUIT BREAKERS

The machine is equipped with two circuit breakers to
protect machine from damage. The Main (20amp) and
Brush (35amp) circuit breakers.
If a circuit breakers should trip during operation,
determine cause, allow motor to cool and then
manually reset breaker (See TROUBLE SHOOTING).
Brush motor circuit breakers will trip due to excessive
overload on pad. Reduce pad pressure or replace pad
if breaker trips. Circuit breakers are located on control
console (Figure 27).
FIG. 27

MACHINE ADJUSTMENTS

FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.

ADJUSTING SOLUTION FLOW

To increase or decrease the maximum solution flow,
turn adjustment knob. Adjustment knob is located near
brush lift pedal (Figure 28).
FIG. 28
OPERATION
13