Versaclean 200 Manual Del Usuario página 4

CAUTION: When the recovery tank reaches capacity,
an automatic float valve blocks vacuum intake (Fig.
5) and the vacuum motors will make a high pitched
noise. When this occurs, switch the machine off
immediately to prevent damage to the vacuum
motors.
10. When cleaning is completed, rinse solution tank with
clear water to ensure no detergents or rinse agents
remain in the tank.
11. Empty and rinse the waste tank thoroughly. This will
help to prevent the formation of damaging deposits
and reduce the growth of odor-causing bacteria.
12. Turn on vacuum motor and allow it to run for 15
minutes to help remove any moisture from the
vacuum motors and help ensure long vacuum life.
1200MS OPERATING INSTRUCTIONS
IMPORTANT: Make sure to control foaming in the
vacuum system. Excessive foam can allow moisture,
carpet fiber and other debris to be drawn through the
vacuum cutoff valve and cause damage to the vacuum
motors. Damage caused by moisture or debris will void
FIG. 2: Rear View
A
C
E
A Solution tank with clear hinged cover
B Wand retention clip
C Vacuum exhaust. Keep clear.
D Product label and serial number
E Dual cords (select models)
07-02052E
All manuals and user guides at all-guides.com
A
(Fig 2 detail)
B
D
F
G
H
I
J
the product warranty. To help reduce foaming, use a
low-foam detergent. Foaming may also occur because of
residues left from previous cleanings. If this happens,
use a defoamer additive. Follow defoamer manufacturer
instructions for proper application.
1. Pre-mix cleaning solution with hot water in a
separate container. Pour mixed solution into the
solution tank of the machine or apply solution
directly to the cleaning surface as directed by
chemical manufacturer.
2. Connect vacuum and solution hoses to machine and
attach to extraction wand or hand tool.
3. Drain waste tank when full using gravity drain and
diverter (Fig. 7), or use the automatic pumpout
feature described below.
4. For auto-fill operation, attach fresh water supply to
freshwater inlet (Fig. 2J) and turn on water supply at
faucet. Tank will begin filling and automatically shut
off when full.
5. If auto-pumpout operation is desired, attach a
regular garden hose to auto-pumpout coupling (Fig.
F
Dual-circuit indicator light (select models)
Pressure gauge (select models)
Pressure regulator (select models)
Auto-pumpout coupling (select models). Keep capped when not
in use.
Auto-Fill coupling (select models)
4
G
H
I
J
VersaClean