Special Accessories - Hansgrohe Metris 31050000 Manual Del Usuario

Ocultar thumbs

Contenido

página de 18

/ 18
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Assembly

The fitting must be installed, flushed and

tested after the valid norms!

1. Flush through the supply pipes.

2. Place the mixer including the sealing washer in

position on the basin / bidet.

3. Slip the fixation piece including the washer

over the threaded pins and tighten the nuts.

4. Connect the supply pipes to the isolation valves;

cold right - hot left.

5. 31050000/31052000/31055000/

31252000/31252000:

Connect the pull rod to the pop-up waste.

The hot and cold water supply's should be of equal

pressures.

Operation

The mixer is activated by lifting the lever handle.

Move to the left = hot water,

move to the right = cold water.

Technical Data

This mixer series-produced with

waterdimmer

(flow limiter)

Rate of flow with waterdimmer:

Rate of flow without waterdimmer:

Operating pressure:

Recommended operating pressure:

Test pressure:

Hot water temperature: max:

Recommended hot water temp.:

Test certificate 31050000/31055000: WRAS

Test certificate 31250000:

Hansgrohe single lever mixers can be used

together with hydraulically and thermically

controlled continuous flow heaters if the flow

pressure is at least 1.5 bars.

If the continuous water heater causes any problems

or there is not enough flow of water, the

waterdimmer

(7a) located behind the aerator

must be removed.

To adjust the hot water limiter on single lever

English

mixers, please see page 14.

No adjustment is necessary when using a

continuous flow water heater.

Spare parts (see page 3)

1.1 screw cover

8.1 diverter knob

8.2 pull rod