Affinity AFB Manual Del Usuario

AFB
EMERGENCY LIGHTING UNIT
Installation and wiring.................................................................................................. Page 2-3
Testing and maintenance ............................................................................................. Page 4
Maintenance ..............................................................................................................Page 5-6
Wiring diagram............................................................................................................Page 6
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
!
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR
SIGNIFICANT PROPERTY DAMAGE
maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations. If you do not understand these
instructions or additional information is required, contact Lithonia Lighting or your local Lithonia Lighting distributor.
!
WARNING:
RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM OR SERVICE WHILE EQUIPMENT IS
! ENERGIZED
.
WARNING:
DO NOT USE ABRASIVE MATERIALS OR SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIXTURE, WHICH
MAY RESULT IN PERSONAL INJURY .
!
WARNING:
RISK OF PERSONAL INJURY –
from carton, handling, installing and maintaining this product.
!
WARNING:
The battery used in this device may present a risk of fire or chemical burn if mistreated. Temperature range 32 ° F -122 ° F (0°C - 50°C)
with Non-CW unit and -22 ° F -122 ° F (-30°C - 50°C) for CW units. Do not disassemble or heat above 70° C (158° F) or incinerate. Battery should not be
used in an application where the temperature is lower than what is rated on the spec sheet. Replace battery only as directed on the battery label and
!
page 4 of these instructions. Use of unauthorized battery voids warranty and UL listing of this product and may present a risk of fire or explosion.
WARNING:
For switched line applications only the PEL unit(s) shall be connected. No other switched products shall be connected on the switched
leg.
•Disconnect A.C. power before servicing.
•All servicing should be performed by qualified personnel.
•Consult your local building code for approved wiring and installation.
•For use Outdoors. Failure to ensure conduit connections are properly protected against water ingress during installation may void
•Do not mount near gas or electric heater.
•Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
•The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•Do not use this equipment for other than intended use.
AND DELIVER TO OWNER AFTER INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
- For your protection, read and follow these warnings and instructions carefully before installing or
This product may have sharp edges. Wear gloves to prevent cuts or abrasions when removing
SAVE THESE INSTRUCTIONS
AFFINITY
warranty.
®