Uline H-7238 Guia De Inicio Rapido página 2

PAGE 2 OF 12
ASSEMBLY CONTINUED
5. Fasten five of the 32" resinwood slats then fasten
Figure 2
6. Repeat this process with each resinwood slat until all
Figure 3
7.
8. Repeat for the second receptacle before
Figure 4
9. In the top ring, remove the three finger-tight cap
Figure 5
another 33" resinwood slat. (See Figure 2)
resinwood slats have been attached to the bottom
ring. (See Figure 3)
Using the same directions listed in steps 2, 3 and
4, line up the top ring with the resinwood slats and
repeat the process until all resinwood slats have
been attached to the top ring. You may now tighten
all bolts, remembering to ensure can is put together
evenly. (See Figure 4)
proceeding to the next step.
screws, flat washers and tee nuts. Leave the slats in
place. (See Figure 5)
0621 IH-7238