Uline H-7238 Guia De Inicio Rapido página 3

PAGE 3 OF 12
ASSEMBLY CONTINUED
Figure 6
Figure 7
Figure 8
Figure 9
10. Place the curved portion of a connector against
the slats on the upper ring. The center point of the
connector should be in line with the center point of
the ring. The holes for the mounting hardware in the
slats should be at the mid point of the connector.
(See Figure 6)
11. From the inside of the receptacle, attach the
connector using 3½" hex lag screws and flat washers.
Maintain firm pressure on the connector when
driving the lag screws. Flip the receptacle over and
repeat steps 9, 10, and 11 to attach the connector
to the lower ring of the receptacle. (See Figure 7)
12. Stand the receptacle back upright. Remove the
finger tight hardware from the three slats on the
second receptacle. (See Figure 8)
13. Slide the slats back into position and move the
receptacles together to hold the slats firmly. Attach
the connector to the second receptacle, repeating
step 9, starting with the upper ring. (See Figure 9)
0621 IH-7238